Remedy: Pull out the print cylinder and set it back.Causes: 509 Master-loading sensor was OFF when the master was checked at a specified drum angle during the master-loading operation.Remedy: Open the master-making unit and rewind the master material on the master roll, and then reset the master, or turn OFF the power and power back ON.215 Faulty gate-array control for the write pulse motor (motor does not stop within set time). 214 Master-positioning sensor is ON at the start of master making. 211 Master-positioning sensor is ON during standby. 202 Master-positioning sensor does not go OFF even when the write pulse motor is reversed during the master-positioning or at start of master-making operation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |